Specifications

SW
No.
Bit
No.
ITEM Soft SW setting and function Factory Setting
21 3 Picture quality priority selection Used to set the default resolution in sending. 0
4 Reserved 0
5
6
7
8
Number of reception start calls Used to set the number of calls before reception in the
auto reception mode. The set range is 0 to 9 times.
Number = 8 × Bit5 + 4 × Bit6 + 2 × Bit7 + 1 × Bit8 rings
Set range : 0 –9
0
0
1
0
22 1
2
3
4
Number of auto reception select Used to set the number of calls before reception in the
manual reception mode. This setup is used as a backup
function when the external telephone does not respond.
The set range is OFF and 1 to 9 times.
Number = 8 × Bit1 + 4 × Bit2 + 2 × Bit3 + 1 × Bit4 rings
Set range : 0(= OFF), 1 –9
0
0
0
0
5 Reserved 0
6
7
8
Result list print Used to set the printing conditions of the result list after
completion of communication.
0
0
1
23 1
2
3
4
Number of recall times Used to set the number of times of recalls when sending is
not normally completed due to busy status of the other
party or a communication error.
The set range is OFF and 1 to 14 times. For some causes
of the communication error, however, the number of times
of recalls must be set to a smaller level.
Recall Times = 8 × Bit1 + 4 × Bit2 + 2 × Bit3 + 1 × Bit4
times
Set range : 0(= OFF), 1 –14
0
0
1
0
5
6
7
8
Recall interval Used to set the recall interval when a transmission is not
normally completed due to busy status of the other party or
a communication error.
The set range is 1 to 15 minutes.
Recall Interval = 8 × Bit5 + 4 × Bit6 + 2 × Bit7 + 1 × Bit8
min
Set range : 1 –15
0
1
0
1
24 1
2
3
4
Remote select number Used to select the first digit of the select request signal
when selecting from the external telephone to FAX
reception.
The set range is 0 to 9.
Number = 8 × Bit1 + 4 × Bit2 + 2 × Bit3 + 1 × Bit4
Set range : 0 – 9
0
1
0
1
5 Remote reception Used to set whether “Remote select number” + “∗∗” from
an external telephone is detected and switched to FAX
reception or not.
1
6 FAX signal reception Used to set whether CNG signal is detected during
OFF-HOOK and switched to FAX reception or not.
1
7 Auto cover paper Used to set whether a cover is attached to the last page in
every transmission or not.
0
8 Reserved 0
1 : Fine 0 : Standard
Bit No. Always
Error/Timer
transmission
Send Never Error
6 0 0 001
7 0 0 110
8 0 1 010
1 : ON 0 : OFF
1 : ON 0 : OFF
1 : ON 0 : OFF
FO-3800M
8 – 27