User Manual

Explanation of headings
SENDER/
RECEIVER
The fax number of the other machine involved in the transaction. In the case
of a transmission, the number dialled appears. In the case of a reception, the
programmed ID of the sending machine appears. If this machine does not
have an ID function, the communication mode will appear (for example,
"G3").
PAGES
Number of pages transmitted or received.
NOTE
OK
- Transmission/reception was normal.
P.FAIL
- A power failure occurred.
JAM
- A problem with the fax paper or document occurred.
NO PAPER
- You ran out of fax paper during reception.
CANCEL
- Transmission was cancelled because the
STOP
key was
pressed, no document was in the feeder, or the other machine requested
transmission using a function which your fax does not have.
COM.E-0
to
COM.E-14
- A telephone line error prevented the transaction.
Explanations of the error numbers are given in the following tables, however,
these are primarily for use by service engineers. In general, you will want to
simply try the transaction again. If necessary, check with the other party to
make sure their machine is functioning properly.
Transmission errors
E-0
Able to recognise handshake signal, but it has errors.
E-1
Cannot recognise the handshake signal from the receiver side.
E-2
Line disconnected during transmission.
E-3
Line disconnected after modem speed fall-back.
E-4
Line disconnected during multi-page transmission.
E-6
Cannot recognize the handshake signal for next page at receiver side.
E-7
No response from receiver side or "disconnect signal" is received at transmitter
side.
E-8
Error was not corrected after the predetermined number of retries because of an
error in a part of a page.
E-11
Error occurred after or whilst reception by the remote (receiving) machine was
revealed to be impossible.
E-12
Error occurred just after fall-back.
E-13
Error occurred after a response to a retransmission end command was received.
Chapter 10 Printing Reports and Lists
74