Service manual

3. 12. Entry data receive

This mode is used to receive the registered data which is sent from

the remote machine and to register the received data in the machine.

When this mode is used to receive the information, the remote ma-

chine must be set to the entry data send mode.

The information to be sent is as follows.

1. Telephone number registration list

2. Sender registration list

3. Setting of optional setting

4. Soft switch setting

5. Junk FAX number

6. Timer reservation data (timer-communicatable type)

7. Bus code No. (only for the type with hold function)

8. Program/group information

9. Security switch for hold time

10. Registration data of caller ID and concerned

11. Setting of printer and concerned

Press

FUNCTION

9 8 7 START START

Press FUNCTION key.

Press key.

Bit1 - 8 are set.

Soft SW-A2 - SW-M2 are set.

S F T SW-A1 = 1 0 0 0 0 0 0 0

S F T SW-A2 = 0 0 0 0 0 0 0 0

S F T SW-M2 = 0 0 0 0 0 0 0 0

Press key during setting.

To finish the settings halfway between

SW-A1 and SW-M2, press the STOP

key. In this case, the setting being done

to the SW No. on display will be nullified

while settings done to the preceding

SW Nos. remain in effect.

The soft switch mode is terminated.

S F T SW-A1 = 0 0 0 0 0 0 0 0

START

DATA No. 1 2 3 4 5 6 7 8

When the COPY key is pressed, the

contents of soft switches are printed.

4. How to make soft switch setting

To enter the soft switch mode, make the following key entries in

sequence.

UX-510U/UX-510C/UX-500U

UX-500C/FO-1460U

2 – 4