Specifications

PROBLEMS AND SOLUTIONS
The printing paper does not come
. The printing paper may be jammed. See “Clearing Jammed
out.
Printing Paper” in this chapter.
● Make sure that the printing paper is properly loaded in your
machine.
~
● Make sure the power is on.
The printing paper comes out blank
. Make sure that the document is loaded properly in the feeder
of the transmitting machine. Make a copy to confirm the
when you try to receive a document.
printing ability of your machine.
● Ask the other party to send higher contrast documents. If the
The received document is faint. ‘
contrast is still too low, your fax may have a problem. Make a
copy to check it.
● The imaging cartridge may need replacement.
Received images are distorted.
. Noise on the telephone line may cause distortion. Have the
other party try sending the document again.
I
.
Make a copy of another document on your fax. If the copy is
also distorted. your fax may have a problem. If the problem
persists. call for service.
. The photoconductor drum may be damaged. Try a new drum
cartridge.
No confidential transmission or .
Check the message in the display. See the next section,
relay broadcast occurs.
“Display Messages”.
. The operation of this equipment on the same line as the
Bell Tinkle
telephone or other equipment with audible warning devices
(New Zealand)
or automatic ring detectors will give rise to bell tinkle or noise
and may cause problem occur, contact your Sharp
authorised Service Centre for information.
10-2
TROUBLESHOOTING