Specifications

,-.
,... ~ ,
CONNECTINGTHE INTERFACECABLE
To use your fax as a printer, you must connect it to your computer with a proper
parallel interface cable. The cable can be purchased from your dealer (it is not
provided with your fax).
The cable connector must be a female 36-pin DDK 57LE-40360-730B (D29)
connector or equivalent.
The cable should be a high-quality shielded cable which is IEEE-1284 compliant,
and it should be less than 3 meters long.
Follow the steps below to connect the cable.
1
Make sure that the power switches of
both the computer and the fax are
turned off.
2
~,
Plug the cable into the parallel
a%
interface port on the rear side of
fax.
%
B
\
q ~
your
3
Fasten the bail clips at each end of
the parallel interface port over the
ends of the cable connector to hold
the connector in place.
r
‘.:.\,
“\
\,
~,
‘ ,.
*
ql ,,, ‘“=-
Ky. .
\-
k “,
A
4
Plug the other end of the cable into
the parallel interFace port on your
computer. (See your computer manual
for details.)
Note: The F-2700hhsends and receives data bidirectionally athigh speed. Some switch
boxes cannot suppoti high-speed, bidirectional transfer of data, and using them may
cause printing errors to occur.
1-10
INSTALLATION
‘,-
\
‘\