Specifications

9
3. You can now enter a Tare weight for this PLU. The displays will
now show the following:
4. Once you have entered the Tare, press the MW key. Step 5 is
Percent Tare programming. This feature can be disabled so if you
do not see the following displays then go to step 6. (Only an
ACOM Authorized Dealer can change this option for you.)
5. At this point you can enter a Percent Tare value. Remember, if
your scale does not show this please go on to step 6. Once you
have entered a %Tare, press the MW key. The displays will next
show:
6. At this point you may type the PLU number that you wish to assign
the above data to and then press the MW key, or you can press
one of the Direct PLU keys to assign the data directly to that key.
Note that if you wish to program the speed keys located on
the numeric keypad, you must refer to them as PLU number 1
thru 6. They cannot be programmed by pressing the actual
key. You are now done! You can repeat this procedure for other
PLUs.
Remember, if you get stuck you can always press the ¿ key to escape
back to regular mode.