Specifications

Sending to the ER-A450T
Page / 12
Designs and specifications are subject to change without notice.
6. Once selected, if the image data complies with the specifications, the image will be displayed.
7. If the image is the correct graphics, then click the [ Send ] button to initiate sending the image to the
ER-A450T. (Fig. 16)
8. The communications setting menu will automatically appear so to verify the settings as follows;
(1) Select the required Baud Rate, Protocol and Communications port for the PC.
Note:
For the Protocol setting, only SIO (Manual) and SIO (Auto) are eligible selections.
(2) Select the required Baud Rate, Protocol and Communications port for the PC.
(When the [ CA/AT ] is used at the ER-A450T) (When the [ SBTL ] is used at the ER-A450T)
(FIG.17)
(FIG.16)
(3) Click [ OK ] when you have selected the necessary settings and the application will begin
downloading the image data to the ER-A450T. (Fig. 19)
(FIG.18)
(FIG.19)