Service manual

ER-A242U SPECIFICATIONS
– 4 –
7. DRAWER
[OUTLINE]
• Standard equipment: Yes (1)
• Max. number of additional drawers: 0
• The drawer consists of:
1) Drawer box (outer case) and drawer
2) Money case
3) Coin case
4) Lock (attached to the drawer)
[SPECIFICATION]
1) DRAWER BOX AND DRAWER
2) MONEY CASE
Layout:
3) LOCK (LOCK KEY : LKGIM7331BHZZ)
8. BATTERY
1) MEMORY BACK UP BATTERY
For memory back up, the dry battery AA (3 pieces) are needed.
1. Memory holding time:
Approx. 1 year after New dry batteries are installed.
2. Battery exchange method:
When the low battery symbol “L” lights up, replace the batteries (3
AA) by the following method;
1) Power on the ECR.
2) Mode switch turn to “REG” mode.
3) Remove the OLD dry batteries (3 pieces).
4) Insert the NEW dry batteries (3 pieces).
5) Confirm the low battery symbol “L” is off.
2) LOW BATTERY
Low battery indication will appear on the left side of display when the
battery voltage is low.
[Display sample]
After finalization
Model name of
the drawer box
SJ423
Size (mm)
420 (W) x 427 (D) x 114 (H)
Material Metal
Bell —
Release lever Standard equipment: situated at the bottom
Drawer open
sensor
—
Separation from
the main unit
—
Separation from the drawer Allowed
Separation of the bill compartments from the
coin compartments
Allowed
Bill separator Allowed
Number of compartments 5B/6C
Location of the lock: Front
Method of locking and unlocking:
To lock, insert the drawer lock key into the lock
and turn it 90 degrees counter clockwise.
To unlock, insert the drawer lock key and turn it 90
degrees clockwise.
Key No: SK1-1
5B/6C
SK1-1
L
o
c
k
u
n
l
o
c
k
CASE 1: When any numeric entry & any item entry is not done or just
after finalization.
The machine can indicate the low battery condition. (Always)
CASE 2: When numeric entry or item entry is done.
Battery condition will not appear.
Exceptionally, when the power is restored after a power failure, the
low battery condition will appear on the display only when the bat-
tery is low.
And the indicator will disappear after any key entry.
“ 0.00”: Battery is OK.
“L 0.00”: Low battery (You have to change the batteries.)
“
L 0.00”: No battery (You have to change the batteries immediately.)
“F 12.34”: Battery is OK.
“L 12.34”: Low battery. (“L” indicate instead of “F”.)
“
L 12.34”: No battery. (“L” indicate instead of “F”.)
Note: “NO BATTERY”: When the “NO BATTERY” is display, the mas-
ter reset is executed at the timing of “POWER
ON” after the “POWER OFF”.