Instruction manual

95
By entering a job code
1. Enter a job code listed in the table shown later and press the
.
and
x
keys in the X1/Z1 or X2/Z2
mode menu window.
2. If needed, enter corresponding values described in the “Data to be entered” column on the table
shown later.
3. Select a device (“DISPLAY” or “REPORT PRINTER”) to receive the output.
4. After the report has been taken, the message “ARE YOU SURE ?” will appear.
Select one of the following actions:
• Select “YES” to reset the sales information.
• Select “NO” to save the sales information.
XXX
. x
Item Description Data to be entered
Available report type in each mode
X1/Z1(Job code)
X1, Z1 (100)1 GENERAL General
2 DEPT./GROUP
Department by
designated range
Starting department
code/ending department
code
X2, Z2 (200)
X1 (110) X2 (210)
X1 (112)
3 DEPT.IND.
GROUP
Individual group total
of departments
Department group no.X2 (212)
X1 (113)
4 DEPT.GROUP
TOTAL
Full group total of
departments
X2 (213)
X1, Z1 (120)5 PLU
PLU by designated
range
Starting PLU code/ending
PLU code
X2, Z2 (220)
X1, Z1 (121)6 PLU BY DEPT
PLU by associated
dept.
Department codeX2, Z2 (221)
X1 (122)
7 PLU IND.
GROUP
Individual group of
PLUs
PLU group no.X2 (222)
X1 (123)
8 PLU GROUP
TOTAL
Full group total of
PLUs
X2 (223)
X1 (128)
13 PLU MIN.
STOCK
PLU minimum stock
X1, Z1 (129)
14 PLU HOURLY
GROUP
PLU group by hour Starting time/ending time
X1 (130)15 TRANSACTION Transaction X2 (230)
X1 (127)
PLU zero sales by
department
Department codeX2 (227)
X1 (124)9 PLU STOCK PLU stock
Starting PLU code/ending
PLU code
X1 (125)10 PLU COST PLU cost
Starting PLU code/ending
PLU code
X2 (225)
X1 (126)11 PLU TOP 20 PLU top 20 Amount or q’tyX2 (226)
X1 (127)
12 PLU ZERO
SALES
PLU zero sales AllX2 (227)
X2/Z2(Job code)
X1 (131)16 TL-ID Total in drawer
X1 (132)
17 COMMISSION
SALES
Commission sales X2 (232)
Starting PLU code/ending
PLU code
~ER-A750(SEEG)-7 97.3.31 3:43 PM Page 95