Specifications

17
(2) Make sure that both the magnet adhesion surface
and the workpiece surface are clean.
CAUTION
If something is caught under the magnet, there is a
danger that the machine may slide off.
Gaps between the magnet adhesion surface and the
workpiece weaken the magnetic holding power. Always
keep the magnet adhesion surface free from foreign
matter (such as metal chips), unevenness, and rust.
(3) Align with punch hole
WARNING
Make sure that the lock screw to fix body position is
securely fastened before drilling.
Loosen the lock screw on the side of the body , and
moves the body back and forth or around to align the
tip of the pilot pin with the punch. Then tighten the
lock screw in the arrow direction.(Fig.26) The lock
screw has the wings and is designed to fasten with
hands. Do not tighten it with a spanner or the like.
※The lock screw can be mounted on either left or right
side of the body.
Plug cushion Rubber
Lock Screw
Lock Screw
(Fig. 26)
CAUTION
Remove the plug cushion rubber and attach the
lock screw.
Insert the removed plug cushion rubber in the screw
hole of the pole plate on the opposite side.
Turn the Handle Ass'y downward to lower the cutter
and align the tip of the Pilot Pin with the punch hole.
(Fig. 27)
3XOOGRZQWRSODFHWLSRI3LQ
RQWRSXQFKKROH
(Fig. 27)
(4) Magnet on
CAUTION
●
Check that the magnet is adhered.
●
When energized, the magnet may exhibit a
buzzing sound or a slight hum.
Turn the magnet switch on. The magnet starts the
adhesion and LED turns white momentarily.
After that, LED indicates the remaining power of the
battery (blinks three times).
Remaining battery power indication
LED
indication
Remaining battery power condition
Green Approximately fully charged
Yellow
Remaining power has decreased slightly
Red
Remaining power has decreased significantly.
Replace the battery pack to a charged battery
pack.
: Blink
(5) How to attach the Guard
Please attach the guard as shown in Fig.28.
(Fig. 28)
(6) Lubrication
Provide cutting oil using the jet oiler. As a guide, it is
desirable to have cutting chips always in wet condition
when drilling to prevent burning of cutting chips.
(7) Electric drill switch ON
WARNING
●
Do not touch the rotating area.
Turn the electric drill switch on. The electric drill
starts rotating.
Rotate the handle Ass’y and lower the electric drill
to start drilling.
(8) Drilling
(8-1) Drilling
Turn the Handle Ass

y downward to start drilling. For
the first 2 – 3 mm of the drilling, slowly feed the drill
motor. (Fig. 29)
Guard