Operation Manual, Quick Start Guide

Table Of Contents

BEFORE USING THE MACHINE

LOAD PAPER INTO THE TRAY 1

Pull out the paper tray.

Gently pull the tray out until it stops.

Push the centre of the pressure plate down until it locks into

place.

Adjust guide plates A and B to match

the longitudinal and transversal

dimensions of the paper to be loaded.

The guide plates A and B are slidable. Squeeze the

separator plate lever and slide to the desired paper size.

Insert the paper into the tray.

• Load the paper with the print side facing up. Make sure

the stack of paper is straight before loading it.

• Place the paper under the roller on the right side of the

tray.

• Fan the paper well before loading it. If the paper is not

fanned, multiple sheets may feed at once and cause a

misfeed.

• After loading the paper, close the guides to the paper

width not to leave the gap from the guides A and B.

• Do not load the paper as shown below.

• To load 11" x 17" paper

Remove the divider plate. Move the divider plate all the way over to the paper feed opening side (right side), and pull

up to remove. Insert the removed divider plate into A.

• The stack must not be higher than the indicator line.

• Do not add paper.

Roller