User`s manual

ICOP Embedded 386SX PC/104 AIO CPU Module User's Manual 19
2.3.2 Setting up a Flash Disk
Before you can use the ICOP-605X’s Flash disk you will have to initialize it
using a software utility called “PC104.EXE”. This program can be found o n
the utility disk in the subdirectory “A:\FLASH”
- Connect a keyboard and floppy disk ICOP-605X to the PC/104 bus and
boot-up your system.
- run PC104.EXE (this is a DOS command line utility)
ICOP-605X FLASH disk initialize program V1.0
FLASH manufacturer : (1)ATMEL (2)SST
Input manufacturer number (1,2) : 1
Input quantity of FLASH (1,2) : 2
Simulation disk:
(1)DISK-A (2)DISK-B (3)DISK-C (4)DISK-D
Input manufacturer number (1,2,3,4) : 1
FLASH-DISK initialize finish.
(Text in bold should be entered by user)
- After running the PC104.EXE configuration program reboot the system,
while holding down the left “Ctrl” key. This will bring you to the “Flash Disk
Utility”
- “CHANGE CURRENT DISK NUMBER” lets you select the drive you want to
assign to the disk, either A, B, C or D
- “CHANGE FLASH DISK SIZE” lets you select the amount of Flash EPROM
chips that are onboard.
- make selections and reboot the system after closing the program
Your disk can now be formatted and setup with normal DOS commands such
as
FORMAT, FDISK, COPY, SYS etc.
Note : when assigning the solid state disk as either C or D, you first have to
run FDISK before formatting the drive !