Setup guide

eCopy ShareScan
®
Installation and Setup Guide | 333
Device setup for MEAP-enabled devices
These instructions describe how to obtain or configure the network settings on a MEAP-enabled
device.
To configure network settings on a MEAP-enabled device.
1 On the device keypad, press Additional Functions.
2 Press System Settings.
3 Press Network Settings.
The Network Settings window appears.
4 Press TCP/IP Settings.
The TCP/IP Settings window appears.
5 Press IP Address Settings.
The IP Address Settings window appears.
6 Verify the following settings and then press OK.
■ DHCP: Not recommended in a domain-based network environment. Do not enable in
a workgroup environment.
■ IP Address: Use of static IP addresses is highly recommended.
■ Subnet Mask: Set according to site guidelines. ShareScan does not use this setting.
■ Gateway Address: Should be blank, unless another MEAP application requires a
specific gateway address.
7 In the TCP/IP Settings window, press DNS Server Settings.
The DNS Server Settings window appears.