Setup guide

22 | Quick Start: Installing and setting up ShareScan
4 To install the JAR files:
■ Select the check box for HP Express Loader, scroll to the bottom of the page, and
then click Install.
■ In the Toolbox section of the Activity Log page, under Device Tools, click Install.
Select the check box for HPAgent, scroll to the bottom of the page, and then click
Install.
5 In the Toolbox section, under Device Tools, click List. Make sure that both applications
— HPAgent and Simple Document Capture (SDC) — are included in the list.
To install the JAR files (using Package Loader):
1 To connect to the HP device:
■ Open a Web browser.
■ In the Address bar, enter device information using the following format:
Format:
http: //<device_name or IP_address>/hp/device/this.loader
Example:
http://10.10.12.241/hp/device/this.loader
■ Press ENTER
■ Log on to the device.
The Package Loader page opens.
2 Check to see whether the JAR files have already been installed; it is important not to install
a JAR file that is already installed on the device.
■ Navigate to the Reloadable Packages section of the page. This section lists all the
installed packages.
■ If ShareScan OP (for Chai2 devices) or HPAgent (for Chai4 devices) and Simple
Document Capture (SDC) are listed in the Package Name column, the JAR files
have been installed. You can now associate the driver with the device (see page 25).
If the packages are not listed, proceed to the next step.
Important! The MFP will restart after the application is installed. You must wait for the device to
complete its startup cycle; this may take several minutes. When the Install Device
Applications page indicates that the application has been successfully installed and
when the MFP has completed its startup cycle, you can install the next JAR file.