Setup guide

eCopy ShareScan
®
Installation and Setup Guide | 19
Installing HP Driver for ScanStation 1.2
The ScanStation uses the HP Driver for ScanStation 1.2 to get input from a supported HP MFP.
You must install and configure it before licensing the device.
To set up a ScanStation to use the HP Driver for ScanStation, you perform the following tasks:
■ Install the application, ShareScanOP_Driver_for_HP.exe, on the ScanStation (see page 20).
■ Install Java Archive (JAR) files on the Java
™
-enabled Hewlett-Packard (HP) device that is
connected to the ScanStation (see page 20). The HP Driver for ScanStation installs two sets
of JAR files on the ScanStation, one set in the Chai2 folder (for older devices) and one set
in the Chai4 folder (for newer devices) (see Table 1).
■ Configure the HP device (see page 24).
■ Associate the HP Driver with the HP device using the HP Driver for ScanStation Tool (see
page 25).
■ License the ScanStation (see page 36).
TABLE 1. JAR files for supported HP MFPs
HP MFP Chai2 folder Chai4 folder
HP LaserJet 4345 Yes No
HP LaserJet 4730 Yes No
HP LaserJet 9040 Yes No
HP LaserJet 9050 Yes No
HP LaserJet 9500 Yes No
HP Digital Sender 9200c Yes No
HP LaserJet M3035 No Yes
HP LaserJet M4345 No Yes
HP LaserJet M5035 No Yes