Setup guide

eCopy ShareScan
®
Installation and Setup Guide | 271
To create a copy of a group:
Sometimes it is easier to copy and edit an existing group of connector profiles than to create a
new group from scratch.
1 In the console tree, right-click Devices and then click Publish connector profiles.
The Publish Connector Profiles window opens.
2 Select the group of profiles that you want to copy.
3 Click Edit.
The Modify Device Profile window opens.
4 Enter a name for the new group, select Save As, and then click OK.
A copy of the group of profiles is saved under the new name.
To use a backup copy of connector profiles on a target device:
1 Start the Administration console on the target device.
2 Import the backup copy from the BackupConnectorProfiles folder on the target device
(see page 137).
To use published profiles on a different device:
1 Start the Administration console on the target device on which you want to use the
published profiles.
2 Import the profiles and publishing information from the eCopyPublishingInfo folder,
which is under the Base location folder on the source device (see page 137).
Note: You can edit the copied group of profiles before saving it to the Base location.