Setup guide

238 | Reference: Connector-specific configuration information
Configuring Scan to eCopy Desktop
After completing the pre-configuration steps, you can configure the connector.
To configure Scan to eCopy Desktop Connector properties:
1 In the console tree, click Scan to Desktop > Properties.
2 Select the Display tab and then specify the settings (see Table 14).
3 Select the Configure tab.
4 Select Scan Inbox/Home Folder Settings and then click Properties.
5 In the Environment Type list, select the environment type, specify the settings (see
Table 52 and see Table 53), and then click OK.
6 If the connector profile uses destinations, select Destination Settings, click Properties,
specify the settings (see Table 54 and see Table 55), and then click OK.
This option allows you to send scanned documents to network locations, such as Windows,
Novell, or FTP folders.
7 Select Inbox Agent > Start Service. The Inbox Agent provides eCopy Desktop with the
path information that eCopy Desktop needs to connect to scan inboxes or network home
directories.
The first time you click Start Service, the Inbox Agent registry settings are automatically
configured.
8 Click Save, select or specify the profile name, and then click Save.
Scan Inbox/Home Folder settings
The environment settings depend on the environment type that you select in the Scan to Desktop
Properties window. The general settings are the same for all environments. The connector
supports the following environments:
■ Windows Active Directory
■ Novell eDirectory
■ Local Computer (Workgroup): Select this option if you do not have a domain controller or
NetWare server on your network, or if you are authenticating in a workgroup. If you select
this option, each user must have an account on the local computer.