Setup guide

eCopy ShareScan
®
Installation and Setup Guide | 11
Installation tasks
Before installing the product, see page 321 for information about hardware, software, and
network requirements.
To install and configure ShareScan, you perform the following tasks:
■ Install the ShareScan JAR (Java™ Archive) file, which contains the ShareScan Client, on
the device.
■ Install the ShareScan software (Services Manager, Administration console, and the eCopy
Connectors supplied with the installation program) on a network computer).
■ License devices.
■ Install a TWAIN or ISIS driver.
■ Install the touch screen driver on the ScanStation. However, you do not need to install this
driver if you have an existing ScanStation on which the driver was pre-loaded.
■ Install the ShareScan software (Services Manager, Administration console, eCopy
Connectors supplied with the installation program, and Client) on the ScanStation.
■ License and configure the ScanStation device.
■ Configure and activate connector profiles.
■ Configure and start the ScanStation Client.
Note: If you are using the ScanStation only with Send to eCopy, you do not need to install a TWAIN
driver. If you are using the ScanStation with Send to eCopy as well as with scanners
configured to use a TWAIN or ISIS driver, you use a single product key to license the
ScanStation