Setup guide

196 | Reference: Connector-specific configuration information
eCopy Connector for SMTP using LDAP
The eCopy Connector for SMTP using LDAP enables users to send scanned documents from an
eCopy-enabled device as e-mail attachments using an SMTP server on the network. When a user
sends e-mail from a personal SMTP account, the system prompts users to log on to validate their
identity. The Global Address List is provided by an LDAP server.
eCopy recommends that you use the Wizard to initially configure a connector profile.
To configure the eCopy Connector for SMTP using LDAP properties:
1 In the console tree, select LDAP/SMTP > Properties.
2 Select the Display tab and then specify the settings (see Table 14).
3 Select the Configure tab.
The Configure tab displays a summary of the settings that you specify using the Wizard or
using the Properties window.
Use the Wizard to specify the basic connector settings (see Table 35).
4 Select the Local Address Books tab and then specify the settings (see Table 20 and see
Table 21).
5 Select the Content tab and then specify the settings (see Table 15).
6 Select the Express tab and then specify the settings (see Table 16).
7 Click Save, select or specify the profile name, and then click Save.
Note: Use the Properties button on the Configure tab only if you need to make custom
modifications after the initial configuration.
Note: This tab allows you to reate, configure, and enable an Internet address book. All the fields are
documented in the referenced tables.