Setup guide

eCopy ShareScan
®
Installation and Setup Guide | 111
Configuring a Toshiba MFP with a GL
Controller
To configure a Toshiba MFP to use with Send to eCopy, you perform the following tasks:
■ Create a scan template group (see page 111).
■ Create and configure scan templates (see page 112).
■ Enable file storage in network folders (see page 114).
You can then scan documents using the scan template (see page 114).
Creating a scan template group
Use the following procedure to create a scan template group on the MFP.
To create a scan template group:
1 Connect to the Toshiba MFP by entering the IP address or its SMB name in the address
bar of Internet Explorer, as in the following examples:
http://10.10.9.88/
http://Solutions-45/
2 Select Scan.
3 Select Templates.
4 Select Template Groups.
5 Select New to create a new template group.
6 Enter a name for the template group, such as “eCopy”.
7 Save the information.