Setup guide

108 | Quick Start: Setting up MFP devices to work with Send to eCopy
Configuring a Toshiba MFP with an e-Bridge
Controller
To configure a Toshiba MFP to use with Send to eCopy, you perform the following tasks:
■ Set up the SCAN TO FILE locations (see page 108).
■ Create a scan template group (see page 109).
■ Create and configure scan templates (see page 109).
■ Secure the MFP (see page 110).
You can then scan documents using the scan template (see page 110).
Setting up the SCAN TO FILE locations
Use the following procedure to set up SCAN TO FILE locations.
To set up the SCAN TO FILE locations:
1 Connect to the Toshiba MFP by entering the IP address or its SMB name in the address
bar of Internet Explorer, as in the following examples:
http://10.1.33.31/
http://Solutions-450/
2
Select the Administration tab and then log in as “Admin” (the default password is
“123456”).
3 Select Save as file.
4 Under Local Storage Path, select Send scanned documents directly to the storage
path.
5 Under Destination, select Use Network folder Destination.
6 Under both Remote 1 and Remote 2, specify the following settings:
Option Description/Setting
Allow the following network
folder to be used as a destination
Select this option.
Protocol SMB
Network Path
\\eCopy_IP\Toshiba_drop\ or \\Share-
Name\Toshiba_drop\
Login User Name and Password A fully-qualified user name (domain\user_name) and password for
the specified machine.