Setup guide

eCopy ShareScan
®
Installation and Setup Guide | 105
5 If the default folder is the network shared folder that you created on the ScanStation (see
page 97), click OK. Otherwise, click Browse, select the target folder, and then click OK.
The Send To Folder window displays the name of the target folder.
6 Click OK to return to the main Network Scanner Tool window.
The Profiles tab now lists the new profile.
7 Click Apply to save the new profile on the MFP or MFPs specified on the Scanners tab
and then click Close.
8 Click OK to quit the program.
Creating a profile that uses an FTP folder
When you configure the MFP, you specify information about the target FTP folder (see page 98)
and the authorized FTP user in a profile.
Make sure that you have the MFP’s IP address before you begin.
To create a profile that uses an FTP folder:
1 Make sure that the MFP is running.
2 Open a Web browser and then connect to the Sharp MFP by entering the address in the
address bar of Internet Explorer, as in the following example:
http://device_IP_address
3 Press ENTER.
The System Information page opens.
4 Under Image Send Management, click Destination and then log on to the MFP.