Setup guide

eCopy ShareScan OP Installation and Setup Guide | 103
Configuring a Ricoh scanning device
Before scanning documents for use with Send to eCopy, you must set up Ricoh's Scan to Folder
or Scan to FTP feature on your Ricoh MFP. Scan to Folder and Scan to FTP enable you to scan
documents to shared folders that other users or applications, such as Send to eCopy, can access.
Refer to your Ricoh documentation or to the Ricoh Support Knowledge Base for information
about setting up Scan to Folder or Scan to FTP.
Scanning documents
Scan documents to the designated network folder that you created for use with Send to eCopy.
The scanning process varies according to the MFP.
Fiery-enabled Ricoh MFPs
The following instructions apply to Fiery-enabled Ricoh MFPs.
To scan documents:
1 Load your originals into the MFP.
2 Select Fiery.
3 Select Scan.
4 Select Preset and then select Destination Preset.
5 Scroll to the eCopy destination and then select Load.
6 Press the Green button to start scanning.
Ricoh controllers on MFPs
The following instructions apply to MFs with Ricoh controllers.
To scan documents:
1 Load your originals into the MFP.
2 Select Scanner.
3 Select Folder.
4 Scroll to the eCopy destination.
5 Press the Green button to start scanning.