Setup guide

100 | Quick Start: Setting up MFP devices to work with Send to eCopy
Configuring a Konica Minolta MFP
To configure a Konica Minolta MFP to use with Send to eCopy, you perform the following tasks:
■ Register a destination.
■ Specify address book settings.
■ Register a “program” for use on the MFP. The “program” refers to a destination and a set
of scan settings that are registered together.
To configure the MFP:
1 Make sure that the MFP is running.
2 Connect to the Konica Minolta MFP by entering the IP address in the address bar of
Internet Explorer, as in the following example:
http://10.10.12.999
The Konica Minolta Web Connection page for a public user opens, displaying
information about the MFP.
3 To register a destination:
■ Click Scan.
The Address Book List page opens.
■ Click New Registration.
The New Registration page opens.
4 To specify address book settings:
■ Select SMB and then click Next.
The Address Book (SMB) page opens.
■ Specify the address book settings (see Table 2) and then click Apply.
■ When the “Address Book registration is complete” message appears, click OK.
The new destination appears in the Address Book list.