Setup guide

92 | Quick Start: Installing and setting up ShareScan
To start the Client:
1 Select the Status tab.
2 Under Client Status, click Start.
The Client appears on the device’s touch screen.
A button appears for each connector that you have configured for the device.
The scanner settings specified on the device’s Scanner Settings tab in the Administration
console appear in the lower left corner of the screen, unless you enabled use of the
TWAIN driver’s interface.
If you are using the Client with Send to eCopy, the settings in the lower left corner of the
screen will not appear.
Note: If you are using ShareScan on a Windows Vista operating system, you must start the Client by
selecting Start > Programs > eCopy Applications > ScanStation Client.
Note: Depending on the device that is connected to the ScanStation, you may be prompted to select
the device the first time that you start the Client or the first time that you select a connector.