User`s guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know Your Printer
- Chapter 3: Operator Panel
- Chapter 4: Windows Operations
- Chapter 5: Macintosh Operations
- Chapter 6: Embedded Web Server
- Chapter 7: Networking
- Chapter 8: Accessories
- Chapter 9: Troubleshooting
- Chapter 10: Clearing Paper Jams
- Chapter 11: Windows Utilities
User’s Guide 8-19
Offset Catch Tray
Accessories
4. Lift up the second lever (1) from the top left corner of the back of the printer to open the
rear cover (2).
5. Remove the screws on both sides of the Offset Catch Tray (1), and while holding up the
Offset Catch Tray, remove the right and left tabs from the holes at the top of the printer
(2).
6. Fasten the right and left thumb screws of the top cover of the paper exit, which was
removed during installation of the Offset Catch Tray, into the holes at the top of the
printer.