\l Manual Channel Preset . Press P/C 1o select “Pr” made. . Depending on the program ma channel you want to preset, press the select single/double digit entry. Select the programmer channel number with the 0~9 digit buttons or the /A buttons. . Press the preset button . Crass the green button (MAN) to enter the manual channel preset mode. Follow either procedure or instruction below. OB W e PRESET USING REAL CHANNEL NUMBERS 1. Press P/C to select CH {terrestrial real channel) or CC (GATE real channel). 2.
T — e ® Sound mute button Press the button to mute the sound. "MUTE” appears on the screen. Press the button again to turn the sound back on. © Sound mode selector {jga) When the set is rec g a stereo programmer: With this selector you can choose money, stereo or sound wide. Press the button to select mono {the same sound is heard from the both speakers). Press again to select stereo. Press again to resume sound wide.
3. Enter the teletext page number using the 0~9 digit buttons (enter three digits) or the channel selector (VA) bunions. 4. mummy steps 2 through 3 until the numbers for the desired pages have been entered. 5, Pres the store bunion (ES)) o memorize the page numbers if you want. The colored brackets change to white. 5. Press the picture button fo exit the teletext mode. b) Fast Page Selection Select the appropriate programmer channel, Press the TEXT/MIX button once to enter the teletext mode.
Before Calling for Repair Further Hints The following conditions do not always denote trouble. Therefore, perform the checks described below before calling for service, Ventilation If the problem cannot be complected by the use of this guide, pull the power plug therefrom selectman setting up the TV, allow free access of air to the ventilation holes in the bottom tidal outlet, and oal for service. and rear panel.
