Specifications

Setup
–
8
–
EN
Connection to a TV
If your TV is compatible with 525 or 625 progressive scanning and you want to enjoy
that high quality picture;
You must select the connection Method 3 above and progressive scanning mode. To set the mode, set “PROGRESSIVE” to
“ON” in the DISPLAY menu so that “P.SCAN” will appear on the display of this unit. See pages 18, 19 for more details.
• You can set “PROGRESSIVE” to “OFF” either in the DISPLAY menu or by pressing and holding PLAY
BB
on the front of
the unit for more than 5 seconds.
• When “PROGRESSIVE” is “ON”, video signals from the unit’s VIDEO OUT and S-VIDEO OUT jacks will be distorted or
not be output at all.
If your TV is not compatible with progressive scanning;
Use this unit in interlace mode. Make sure that no “P.SCAN” is on the display of this unit. If so, set “PROGRESSIVE” to
“OFF” in the DISPLAY menu so that “P.SCAN” on the display of this unit will disappear.
CAUTION:
• Be sure to turn off the unit and equipment to be connected before connecting.
• Read through the Operation Manual for the equipment to be connected.
• Be sure that the colours of the jacks and plugs match up when connecting the cable.
• Be sure to keep the unit connection cables separate from the TV antenna cable when you install the unit, because it
may cause electrical interference when you are watching television programmes.
• DTS audio cannot be produced with an analogue connection.
Basic TV connection
CAUTION:
• Connect the unit directly to the TV. Do not connect the unit to a VCR,
then connect the VCR to the TV. Copyright protection in the VCR could
distort the picture playing on the unit.
VCR
This unit
TV
NOTES:
• If you want to listen to the audio through audio equipment, connect only the S-Video or Video cable to the TV.
• When the unit is connected to a TV using both a Video cable and an S-Video cable, only the S-Video connection is
enabled (the Video connection is disabled).
• You will not be able to hear all of the sound being output by the unit if you use the Video/Audio cable (supplied) to a
monaural TV that has only one AUDIO input jack.
Connections
AUDIO OUT
DIGITAL AUDIO OUT
COAXIALOPTICAL
LY
VIDEO
OUT
C
B / P B S-VIDEO
OUT
C
R / P R
COMPONENT
VIDEO OUT
R
4
AUDIO IN
LR
AUDIO OUT L
R
VIDEO IN
Y
VIDEO
OUT
S-VIDEO
OUT
S-VIDEO IN
CB
Y
C
R
COMPONENT
VIDEO IN
or
PB
Y
P
R
Y
C
B / PB
CR / PR
COMPONENT
VIDEO OUT
(Analogue) AUDIO OUT VIDEO OUT
TV
Method 1
Good pictureBasic Audio
Method 2 Method 3
Better picture Best picture
S-VIDEO OUT COMPONENT VIDEO OUT
Video
cable
(supplied)
Audio cable
(supplied)
S-Video
cable
(commercially
available)
Component
Video cables
(commercially
available)
This unit
E6146AD_0523 5/23/05 3:21 PM Page 8
Downloaded from www.Manualslib.com manuals search engine
Downloaded From Disc-Player.com Sharp Manuals