Product specifications

[11]
SERVICE AND MAINTENANCE
8hrs/Daily 40hrs/Weekly Annually
Lubricate PTO Shaft
xxx
Lubricate jockey Wheels
xxx
Lubricate Blade Spindle
xxx
Check Gear Box Oil Level
xx
Clean Machine
x
Lubricate and PTO Shaft Cover
x
3.2.4 PTO SHAFT MAINTENANCE
The PTO shaft is designed to telescope to allow for dimensional changes as the machine goes through its operating
range. A tubular guard encloses the driving components and is designed to remain stationery on a turning shaft
when required. The shaft should telescope easily and the guard turn freely on the shaft at all times. Annual
disassembly, cleaning and lubrication is recommended to ensure that all components function as intended. To
maintain the shaft, follow this procedure:
1. Remove the shaft from the machine.
2. Pull shaft apart.
3. Use a screwdriver to pry the tabs out of the sleeves on each end. There are 3 tabs per guard.
4. Pull the shaft out of the plastic tubular guard.
5. Use a solvent to clean the male and female portions of the telescoping edge.
6. Apply a light coat of grease to each end.
7. Clean grooves on each end where the tabs are located. Clean each tab also.
8. Apply a light coat of grease to each groove.
9. Insert the shaft into its respective guard and align the slots with the groove.
10. Insert the tabs through the slots and seat in the grove.
11. Check that each guard turns freely on the shaft.
12. Assemble the shaft.
13. Check that the shaft telescopes easily.
14. Replace any components that are damaged or worn.
15. Install the shaft on the machine.
3.2.5 GEARBOX MAINTENANCE
The gearbox used on the Slasher will give many years of trouble-free service with minimal maintenance
requirements. Maintain the gearbox by following this procedure:
Oil level:
 Remove the level plug from the rear or side of the gearbox.
 Add oil through the filler plug located on top of gearbox until oil comes out of level plug.
 Add through the fill plug if required.
 If gearbox has a dipstick on filler plug, then fill to indicator mark.
IMPORTANT: Check the oil level only when the unit is cold and the machine is on the level.