Product specifications

[10]
SERVICE AND MAINTENANCE
2. Gear Box Oil:
Use SAE 90 Gear oil:
3. Storing Lubricants:
Your machine can operate at top efficiency only if clean lubricants are used. Use clean containers to handle all
lubricants. Store them in an area protected from dust, moisture and other contaminants.
3.1.2 GREASING
1. Use a hand-held grease gun for all greasing.
2. Wipe grease nipple with a clean cloth before greasing, to avoid injecting dirt and grit.
3. Replace and repair broken nipples immediately.
4. If nipples will not take grease, remove and clean thoroughly. Also clean lubricant passageway.
Replace nipple if necessary.
3.2 Maintenance
The recommended period is based on normal operating conditions. Severe or unusual conditions may require
more frequent maintenance
.
3.2.1 8 HOURS OR DAILY MAINTENANCE
1. Check and screw all nuts and bolts in connection parts.
2. Check the oil in gearbox. Fill up to line if it’s necessary.
3. Pump grease into each grease nipple three to five times.
4. Clean the implement; take away all grass and mud.
3.2.2 SEASON MAINTENANCE
1. Check the machine as above for daily maintenance.
2. Check the oil in gearbox; replace it if it’s contaminated.
3. Check the bearings of blade spindles for wear and tear. If warn, disassemble, clean and replace them if it is
necessary, grease as required.
4. Check the distance between bearings and gears. Adjust them if it’s necessary.
3.2.3 ANNUAL MAINTENANCE
1. Thoroughly clean the Slasher of mud and grass.
2. Drain the gearbox and clean it thoroughly. Fill with new gear oil up to the indicated oil level.
3. Check and clean blade axles. Replace oil seals and grease them.
4. Check all blades, replace them if they are warn out or damaged.
5. Remove the drive shaft from the machine. Pull the PTO shaft apart. Check and replace any components that
are damaged or worn. Install the PTO shaft on the machine. The PTO shaft should telescope easily and the
guard turn freely on the shaft