User Manual

GB-96
Troubleshooting
■ VCR/DVD
■ VCR
Problem
• No power
• The Remote does not work.
• No picture
• Dew
Suggested Solution
• Is the power cord connected properly?
• Is the power cord firmly plugged into the power outlet?
• One of the safety mechanisms may be operating. In this event,
unplug the Unit from the power outlet briefly and then plug it in
again.
• Are the batteries loaded correctly?
• Are the batteries flat?
• Is the signal emitter on the Remote pointing at the Unit?
• Is the Remote too far from the Unit, or is there any obstacle between
the Remote and the Unit?
• Did the VCR/DVD CHANGE Switch change correctly?
• Did the VCR/DVD SELECTOR change correctly?
• See page 6 for information.
Possible Cause/Solutions
• Check all the cables are correctly connected.
• Check your TV manual for correct tuning of your TV.
• Reset the VCR and complete AUTO INSTALLATION again. (Refer
to VCR Reset on page 38.)
• Make sure the power cord is plugged in.
• Make sure the wall socket has power .
• Make sure the TV is set to the video channel.
• Check all connecting cables.
• Adjust the tracking using CH '/".
• Try another tape.
• The video heads may have been contaminated - refer to a SHARP
Service Facility.
• Ensure the VCR is connected to a stereo TV with a SCART lead.
• Programme may not carry stereo.
• The record-protection tab has been removed from the cassette.
The following problems do not always denote a broken this unit. Perform the checks listed below before calling
service.
Problem
• TV will not tune in to the VCR.
• Auto Installation screen does not
appear when the VCR is switched
on
or Auto Installation is not complete.
• Display is not working.
• No picture appears.
• Playback picture is snowy.
• Playback/Recording does not play
back in Stereo.
• Tape is automatically ejected when
pressing
ÆÆ
ÆÆ
ÆREC or TIMER ON/OFF.
DVNC65SE096_101.pm6 9/10/02, 10:31 am96