User Manual

The following steps should only be performed if there is a
power failure or if this unit is unplugged for more than 1 hour.
Turn on the TV and select the video channel on the TV.
Press
OPERATE, then VCR.
Press K or L repeatedly to select your desired language.
Press MENU.
4
3
2
1
Turning on Your VCR/DVD
Press VCR, then MENU.
Press K or L to select INITIAL, then press B.
Press K or L to select LANGUAGE, then press B.
Press K or L repeatedly to select your desired language,
and MENU to confirm.
4
3
2
1
Changing the Language
–
12
–
EN
SETTING UP YOUR VCR/DVD COMBINATION
Playing Dolby Digital (5.1 channel), DTS or MPEG audio
Connecting an amplifier with a Dolby Digital/ DTS/ MPEG Audio digital surround processor to your VCR/DVD’s coaxial digital
jack provides richer and more powerful audio play.
C
C
Digital connection to a processor or amplifier with a coaxial digital input jack
You can make this connection using a coaxial digital cable.
NOTES:
• This connection is not possible if the processor or amplifier to which you want to connect does not have a coaxial digital
input jack.
• ANALOG AUDIO OUT and AV (TV) of the VCR/DVD are not available on the DTS audio.
DIGITAL IN
COAXIAL
To coaxial digital
input jack
Coaxial digital cable
(commercially available)
Dolby Digital (5.1 ch) /
DTS / MPEG Audio
processor or amplifier
DVD
DIGITAL
AUDIO OUT
ANALOG
AUDIO OUT
S-VIDEO
OUT
COAXIAL
L
R
VCR AV2 (DECODER)
AV1 (TV)
DVD/VCR
AERIAL
RF OUT
To COAXIAL
DIGITAL AUDIO
OUT jack
VCR/DVD SET UP
Video Channel setting will be necessary, if your VCR/DVD is
connected to the TV via the round coaxial cable.
Press VCR.
Insert a pre-recorded tape into the cassette compart-
ment.
Playback will start automatically.
If playback does not start, press PLAY.
Select and adjust your TV to channel 36.
• If the playback picture appears on the TV screen, con-
tinue with step .
• If channel 36 is set for broadcasting, or interference
lines appear on the picture, the RF converter must be
set to a different channel between CH22 and CH69.
Continue with step .
4
9
3
2
1
Video Channel Setting
Press MENU.
Press K or L repeatedly to select INITIAL, then press B.
Press K or L repeatedly to select RF OUT, then press B.
The RF OUT CH menu will appear.
Press K or L to select a channel which is not used for
broadcasted between channel 22 and channel 69 in your
area, and B to confirm.
Press MENU to exit.
Set the TV channel to the RF OUT CHANNEL which was
selected on the VCR/DVD. A picture from the VCR/DVD
will appear on the TV screen. If a picture does not
appear, repeat steps to using a different channel
which is not used for broadcasting.
Press STOP to stop the tape.
NOTES:
• You may also access the RF OUT CH menu by pressing
and holding MENU on the remote control for 3 seconds
during power off until the RF OUT CH menu appears.
• If this unit and your TV are connected using a SCART
cable, the RF converter may be switched off to avoid any
possibility of interference. To switch off the RF converter,
follow steps and to above and press L repeat-
edly until “--” appears next to RF OUT CH. Press B , then
press MENU to exit.
641
9
84
8
7
6
5
4