User`s guide

44 Endcaps

MX1 Reference Guide E-EQ-MX1RG-D

Scanner Endcaps

Refer to the MX1 Installation and Operator’s Guide and the section titled “Scanner

Warnings and Labels” for important laser safety information before using the scanner.

The MX1 can be outfitted with a laser scanner endcap module or the RS-232/Scanner

combination module.

The

MX1 Barcode Scanner Endcap is used to collect barcoded data from any nearby compatible

barcode label. Depending on the size of the barcode, size of bars and spacing and quality of the

barcode, the scanners are used to read barcodes at the distances shown in the “Integrated Scanner

Programming Guide”, available on the LXE Manuals CD-ROM, under “Decode Zone”.

After running the program, BCWEDGE, on the MX1 first -- the LXE scanner modules are

activated when the Scan button or the trigger on the optional handle is/are depressed. Tethered

scanners are activated only when the trigger on the tethered scanner is depressed. See the previous

section titled “RS-232 Endcap” for the RS-232/Scanner serial port pinouts.

Scanner Endcap LEDs and

Beeper

1. Laser On Indicator

2. Beeper

3. Good Read Indicator

Figure 2-9 Scanner Endcap LEDs and Beeper

The left LED (1 - Laser On Indicator) on the top of the laser barcode endcap will light, indicating

laser emission when the laser beam is being emitted. Following a good read, the right LED (3 -

Good Read Indicator) flashes, indicating a successful scan. Beeps may be heard (2) after a good

read, depending on the application running on the

MX1. The beep function is activated by

external software programs running in the MX1.

The laser automatically turns off after a successful read and is ready to scan again when the Scan

key (or the trigger) is pressed.

When necessary, use a damp, soft cloth to clean the laser module lens or housing.

Laser scanner parameters are programmed using barcodes in the “Integrated Scanner

Programming Guide”, available on the LXE Manuals CD-ROM.

To ensure proper operation, reboot the MX1 after programming Laser Scanner parameters.