User`s guide

NET.CFG Parameters 119
E-EQ-MX1RG-D MX1 Reference Guide
Auth_type
This parameter is used to enable and manage the 802.11 WEP encryption. The radio card will
only associate with APs that support the same Auth_type.
Valid: “Open_System” or “Shared_Key”
Default: “Open_System”
Encrypt_Key#
Updates the first, second, third or fourth encryption key, according to the value of #.
For Symbol 4121 series radio cards, use 5 pairs of hex digits for 40 bit encryption. Use 13 pairs
of hex digits for 128 bit encryption.
encrypt_enable
Enables encryption on Symbol 4121 series radios.
Valid: yes or no
Default: yes
Note: This parameter was removed from the Symbol NET.CFG file by LXE effective 11/ 2003.
Encrypt_Key_ID
The key ID indicates which key the adapter is to use for encrypting packets.
Valid: 1 to 4
Default: 1
Note: This parameter is valid for Symbol FHSS radios only.
Encrypt_Enable_Index
Previously named encrypt_key_index. This parameter indicates which key the adapter is to use for
encrypting packets for transmission. Zero means No Encryption (i.e. turn encryption off), and
numbers 1 through 4 mean turn encryption on and use the specified key (i.e. key #1, key #2, key
#3 or key #4). The key to be used to decrypt packets being received is contained in the received
packet.
Valid: 0,1,2,3,4
Default: 0 (No Encryption)
Note: This parameter is valid for Symbol 4121 series radios only.
diversity
Set diversity to “both” for two antennas and “A” for one antenna.
Default: both
Tx_rate
Use this parameter to specify that rates at which the radio is allowed to operate. If no rates are
specified, the radio will use all available rates.
Valid: 1 1 Mbps
2 2 Mbps
5 5.5 Mbps
11 11 Mbps