User`s guide

E-EQ-MX1RG-D MX1 Reference Guide
Chapter 6 RF Network Configuration
Introduction
Note: The information and programs in this section only pertain to LXE’s 2.4GHz system
radios. They do not work with LXE’s 900MHz system radios. Set / adjust 900MHz
radio parameters using the terminal emulation CONFIG utility.
Change the 2.4GHz dio parameters by editing the NET.CFG file in the PCTCP directory. This can
be done with any ASCII text editor or NED. The NET.CFG file is the configuration file used by
the radio card’s ODI driver. The NET.CFG file determines the wireless network name, the
workstation name and other information regarding the wireless system.
2.4GHz radio parameters cannot be changed using LXE’s terminal emulation (TE) configuration
utilities.
The Sockets software package provides an interface to all of the TCP/IP parameters. Parameter
configuration is performed by editing the file SOCKET.CFG.
Note: See section titled “Quick Start – Configure the Software” for instruction on using
NED.EXE to edit the NET.CFG and SOCKET.CFG files.
SNMP DOS Agent
The SNMP DOS agent executable resides in the \AGENT directory. For information on enabling
the SNMP Agent, please refer to the “DOS Autoconfigurator Instructions”. For details on Agent
operation, please refer to the “SNMP Agent Reference Guide”. Both manuals are available in
electronic format on the LXE Manuals CD.
The agent is placed into memory as a TSR and uses approximately <70k of memory. When the
agent is not being polled, it is invisible to the user. When it is being polled, there is a slight delay,
depending on how much data is being retrieved by the agent.