User's Manual

EN-5
MAINTENANCE MODE
Should any of maintenance indicators appear in the display, follow the instruction:
CC
Mode Reason Action required
CC
1
CC2
Operation time of magnetrons exceeds
1,250 hours.
Call for service to replace the parts promptly. Failure to
replace parts that have exceeded recommended operation
time
may cause failure of the microwave oven.
CC
4 Operation time of the control unit, relays,
switches
exceeds 200,000 times.
CC
3 Operation time of exhaust motor exceeds
3,000
hours.
Even
though CC3 is displayed, your oven can still be
operated
for short periods of time. Call for service to
replace
parts promptly.
NOTE:
1. The CC and “ * “ indicator will appear in the display when recommended parts life is exceeded. The CC and “ * “
indicator can be cleared by pressing the STOP/CLEAR pad. Call for service to replace the parts promptl
y. Failure to
replace
parts that have exceeded recommended operation time may cause failure of the microwave oven.
2.
If one maintenance mode or more than one maintenance mode occurs at the same time, the display will show CC
and
the numbers of the modes separated by a period. For example, if CC1 occurs, the display will show CC and 1
reciprocally
or if CC2 and CC4 occur at the same time, the display will show CC and 2.4. reciprocally.
GROUNDING INSTRUCTIONS
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock
by
providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire
with
a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance
with
the National Electrical Code and local codes and ordinances.
WARNING – Improper use of the grounding plug can result in a risk of electric shock. The electrical requirements
are
120Volt, 60Hz AC only, 20 Amp or more (R-CD1200M); 230/208 Volt, 60 Hz, AC only, and 20 Amp or more (R-CD1800M,
R-CD2200M)
fused electrical supply. It is recommended that a separate circuit serving only this appliance be provided.
When installing this appliance, observe all applicable codes and ordinances
. If it is necessary to use an extension cord,
use
only a 3-wire extension cord that has a 3 blade grounding plug and a 3-slot receptacle that will accept the plug on
the
appliance. The marked rating of the extension cord should be AC120 Volt 20 Amp (R-CD1200M), AC230/208 Volt
20
Amp. (R-CD1800M, R-CD2200M). Consult a qualified electrician or serviceman if the grounding instructions are not
completel
y understood or if doubt exists as to whether the appliance is properly grounded.
Plug Configuration
Radio or TV Interference
Should
there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven
is
on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and
signal
of receiving antenna.
NEMA
6-20P
R-CD2200M
NEMA
6-15P
R-CD1800M
NEMA
5-20P
R-CD1200M