User's Manual

10
PROCEDURE DISPL AY
･ If the electrical power supply to your microwave
oven should be interrupted, the display will inter-
mittently show
88:88 after the power is reinstated.
If this occurs during cooking, the program will be
erased. The time of day will also be erased. Simply
touch STOP/CLEAR and reset the clock for the
correct time of day.
00 (hour) will flash.
BEFORE OPERATING
･ Before operating your new microwave oven make
sure you read and understand this operation
manual completely.
･ Before the oven can be used, follow these
procedures:
1. Plug in the oven. Close the door. The oven display
will then begin flashing
88:88 .
2. Touch STOP/CLEAR.
will appear.
3.
Set clock. See below.
4. Condition the heaters by heating oven without
food. See page 11.
::
::
:
TOSETTHECL OCKTOSETTHECL OCK
TOSETTHECL OCKTOSETTHECL OCK
TOSETTHECL OCK
･ Suppose you want to enter the correct time of day
12:30 (A.M. or P.M.).
1
Touch CLOCK.
Enter the correct hour by
rotating the TIME controller.
2
3
Touch CLOCK again.
STOPSTOP
STOPSTOP
STOP
//
//
/
CLEARCLEAR
CLEARCLEAR
CLEAR
Touch STOP/CLEAR to:
1. Erase if you make a mistake during programming.
2. Cancel timer.
3. Stop the oven temporarily during cooking.
4. Return the time of day to the display.
5. Cancel a program during cooking, touch twice.
MANUAL OPERATION
Your oven can be programmed for 95 minutes (95.00)
using the TIME controller. The input unit of cooking (de-
frosting) time varies from 10 seconds to five minutes. It
depends on the total length of the cooking (defrosting)
time as shown on the table below:
MICROWA V EMICROWA V E
MICROWA V EMICROWA V E
MICROWA V E
TIMECOOK INGTIMECOOK ING
TIMECOOK INGTIMECOOK ING
TIMECOOK ING
PROCEDURE DISPLAY
1
Enter cooking time.
Touch START
2
There are six preset power levels. Using lower power
levels increases the cooking time which is recom-
mended for foods such as cheese, milk and long slow
cooking of meats. Consult cookbook or recipes for spe-
cific recommendations.
･ Suppose you want to defrost for 5 minutes at 30%.
once 100% High
twice
70% Medium High
3 times 50% Medium
4 times 30% Med Low /Defrost
5 times 10% Low
6 times 0%
PROCEDURE DISPL AY
1
Touch MICRO
4 times or hold down
until the desired power
level appears.
2
3
Enter defrost time.
Touch START.
4
When the defrost time is complete, a long tone
will sound and
will appear in the display.
x 4
Enter the correct minute by
rotating the TIME controller.
Touch CLOCK again.
4
5
･ Suppose you want to cook for 5 minutes at 100%.
CookingTime:CookingTime:
CookingTime:CookingTime:
CookingTime:
Increasingunit:Increasingunit:
Increasingunit:Increasingunit:
Increasingunit:
0-5 minutes 10 seconds
5-10 seconds 30 seconds
10-30 minutes 1 minute
30-95 minutes 5 minutes
TOSETPOWERL EV ELTOSETPOWERL EV EL
TOSETPOWERL EV ELTOSETPOWERL EV EL
TOSETPOWERL EV EL
You can program up to 3 automatic cooking sequences.
Follow directions on page 20. Note that the power level
must be entered first when programming multiple sequences.
00 (minute) will flash.
Touch MICRO
Approximate
Percentage
of Power
Commmon Words
for
Power Level
You can rotate the TIME controller clockwise or counter-
clockwise. If you rotate it counter-clockwise, the cooking
time will decrease from 95 minutes by degrees.