Product guide

23
Replacing a Gobo
Gobo-wheel with rotating gobo’s
1. Disconnect mains power supply and set the switch to OFF.
2. Make sure that the gobo you want to insert has the same size. For the right size, see below.
Fig. 8
3. Loosen the 4 screws on top of the housing. Remove the maintenance cap.
4. Turn the gobo wheel, with the gobo you want to remove, to the upside.
5. Gently lift up the gobo holder 10º and then gently pull out the gobo from its position.
6. Very carefully take the gobo out of the gobo holder with a pair of pliers.
7. Place the new gobo in the gobo holder. Carefully put the pinchcock back, gently press the pinchcock
a little bit together. Possibly use a pair of pliers to press the pinchcock a little bit together.
8. Put the gobo holder back under the pressing snap and push it back.
9. Replace the maintenance cap and fasten all screws.
Fig. 9
Glass Gobo Orientation
Coated glass gobos are inserted with the coating against the rim of the holder (away from the spring).
Textured gobos are inserted with the smooth side against the spring. This provides the best results when
combining rotating gobos.
When an object is held up to the coated side When an object is held up to the uncoated
there is no space between the object and its side there is a space between the object and
reflection. The back edge of the gobo cannot its reflection. The back edge of the gobo can
be seen when looking through the coated be seen when looking through the uncoated
side. side.