Specifications


General control
To turn the power on■
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power
stand-by mode.
Display brightness control■
When the unit is turned on, you can adjust the display brightness
by pressing the DIMMER button on the remote control.
Dimmer 1
Dimmer 2
Dimmer off
(Display is dim).
(Display is bright).
(Display gets dimmer).
Volume auto fade-in■
If you turn off and on the main unit with the volume set to
27 or higher, the volume starts at 16 and fades in to the
last set level.
Volume control■
Press VOL +/- to increase or decrease the volume.
Muting■
The volume is muted temporarily when pressing the MUTE button
on the remote control. Press again to restore the volume.
Direct key power on function■
When you press any of the following buttons, the unit
turns on.
iPod, CD/USB, AUDIO IN, TUNER, NETWORK on the
remote control: Selected function is activated.
/ button on the main unit: The unit turns on and
playback of the last function will start (CD, TUNER,
USB, iPod, AUDIO IN, NETWORK)
Auto power off function■
The main unit will enter the stand-by mode (when iPad, iPod or
iPhone is not connected) after 15 minutes of inactivity during:
iPod: Not docked.
Audio In: No detection of input signal.
CD: In the stop mode or no disc.
USB: In the stop mode or no media.
Note:
However, if iPod or iPhone is docked, the unit will begin
charging.
“Charge Mode” will be displayed.
●
●
Auto power on■
During stand-by mode, when you select DK-KP95PH
speaker through AirPlay icon on your AirPlay device, the
unit will automatically power on to Network function and
stream the music from your AirPlay device.
This condition applies when:
The AirPlay network has previously been set up
between the unit and your AirPlay device.
Set the Network Stand-by mode to ON. (refer page 7)
AirPlay auto switch■
During other function (CD, TUNER, USB, iPod, Audio In),
when you select DK-KP95PH speaker through AirPlay
icon on your AirPlay device, the unit will automatically
switch to Network function and stream the music from
your AirPlay device.
This condition applies when:
The AirPlay network has previously been set up between
the unit and your AirPlay device.
X-Bass control■
When the power is rst turned on, the unit will enter the
extra bass mode which emphasises the bass frequencies,
and “X-BASS” indicator will appear. To cancel the extra bass
mode, press the X-BASS button on the remote control.
Bass control■
Press the BASS/TREBLE button to select “Bass”.
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the bass. “X-BASS” indicator will disappear.
- 5 ↔ - 4
........
↔ + 4 ↔ + 5
Treble control■
Press the BASS/TREBLE button to select “Treble”.
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the treble. “X-BASS” indicator will disappear.
- 5 ↔ - 4
........
↔ + 4 ↔ + 5
Function■
When the FUNCTION button on main unit is pressed, the
current function will change to different mode. Press the
FUNCTION button repeatedly to select desired function.
CD FM MONOFM STEREO
AM
Audio In iPod USB
NETWORK
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or
the AC power lead becomes disconnected.
●
●
�
�
�
�