Operating instructions

E-6
● The message “ This accessory is not made to work with
iPhone” or similar, may appear on the iPhone screen
when:
- battery is low.
- the iPhone is not properly docked (eg. slanting).
If this occurs, remove and re-dock the iPhone.
● This product is made for iPod, iPhone and iPad. To
prevent random interference when iPod, iPhone or
iPad is connected, the headphone output is disabled,
and “HP INVALID” will be displayed.
You may also experience brief audio interference
during incoming calls.
● The headphone output is switched off during inserting
iPod, iPhone and iPad unit. This is an Apple product
specification.
1 Press the POWER ON/STAND-BY button to turn the power on.
2 Press the USB button on the remote control or FUNCTION button
repeatedly on the main unit to select USB function.
3 Connect iPod, iPhone or iPad to the unit. “USB/iPod” will appear.
4 Press the / (USB / ) button to start playback.
Note:
Stop button ( ) is invalid during iPod, iPhone or iPad
playback
●
Sound will only switch from iPhone to the main unit after
authentication process is completed in approximately 10
seconds.
● Incoming calls will pause the playback.
● Once the calls are answered, the conversation can only be
heard through the built-in iPhone speaker. Turn on the
iPhone speaker or undock the iPhone to start conversation.
Caution:
Unplug all accessories from the iPod or iPhone before
inserting it into the dock.
Note:
Docking station is not recommended for iPad connection.
For iPod nano or iPod touch :
For additional support, apply dock spacer (supplied) as shown.
Listening to the iPod, iPhone or iPad (continued)
■ iPod, iPhone and iPad connection via USB terminal
1 Insert the connector to the iPod, iPhone or iPad.
2 Place the iPad to the stand for iPad.
3 Connect the iPod,
iPhone or iPad to the
unit via USB connector.
■ iPod, iPhone or iPad playback via USB terminal
■ iPhone playback
iPad
Connector
iPad
Stand for iPad
USB
File name
■ iPod and iPhone connection (Dock only)
1
Open the docking station for iPod and
iPhone by pulling up the cover.
2 Dock your iPod or iPhone into the unit.
1 Peel off the double sided tape separator.
2 Place the spacer between the two ribs of the iPod docking
cover as shown.
■ iPod or iPhone playback
1
Press the POWER ON/STAND-BY button to turn the power on.
2 Press the iPod button on the remote control or FUNCTION
button repeatedly on the main unit to select iPod function.
3 Insert iPod or iPhone unit into the dock of main unit. “DOCK
OK” will appear.
4 Press the / (iPod / ) button to start playback.
■ Navigating the iPod, iPhone or iPad menus
1 Press the MENU button to view the menu on iPod, iPhone or
iPad unit. Press it again to go back to previous menu.
2 Use the PRESET ( or ) button to select an item on the
menu and then press ENTER button.
iPhone
Dock connector
iPhone (bottom)
Dock for iPhone
Rib
iPod
docking
cover
Dock spacer
Peel off
separator
POWER
Downloaded From DvDPlayer-Manual.com Sharp Manuals