Operating instructions

DK-A10 Remote control
DK-A10BK
While pushing the locking tab toward the center of the
remote control, slide out the battery holder.
2 Remove the old battery from the battery holder, insert the
new battery and then slide the battery holder back into the
remote control.
Remote sensor
Notes concerning use:
• Replace the battery if the operating distance is reduced or if the
operation becomes erratic. Purchase "CR 2025", coin lithium
battery.
• Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
• Exposing the sensor
on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit if this
occurs.
• Keep the remote control away from moisture, heat, shock, and
vibrations.
• Test of the remote control
Check the remote control after checking all the connections (see
page 10 -11).
Point the remote control directly at the remote sensor
on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you
can enjoy music.
Positive
(+)
side up
o
~~
Battery holder
l j Polarity (+) symbol
!?:erytype
Locking tab
• Battery installation
This product contains a CR Coin Lithium Battery which contains
Perchlorate Material - special handling may apply, California
residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/
~aCk of remote control
,,, ~Cking tab
Precautions for battery use:
• Remove the battery if the unit will not be used for long periods of
time. This will prevent potential damage due to battery leakage.
Caution:
• Do not use rechargeable battery (nickel-cadmium battery, etc.).
• Replace only with the same or equivalent type.
• Installing the battery incorrectly may cause the unit to malfunction.
• Danger of explosion if battery is incorrectly replaced.
• Batteries (battery pack or battery installed) shall not
be exposed
to excessive heat such as sunshine, fire or the like.
12