User manual

28
10.2 Connecting the modules to VarioPro
Undo the screws on the left or right ends of VarioPro (depending on which side the
modules are to be connected) and remove the black facing.
The above image shows a side view of a VarioPro. On the left and right are the
deep-set screws which hold the facing on. Once these screws have been taken out
the black facing can be removed. Small metal blocks are delivered with the modules
which are used to secure the modules with these same screws.
The red plugs are electrical contacts between the Braille display and the module. The
ribbon-cable supplied with the module is inserted into this connector. Finally, the
facing can then be screwed onto the module.
Further modules can attached in the same manner.
The image shows a VarioPro with attached status module.