Service manual

-
PC - l600
6-2. Soldering FPC and connector
Insert the SO ·pin male connector (GCNCM1295CC6J) and
the SO-pin female connector (QCNCW1293CCZZI to the
FPC P WB (OPWBM 1009ECZZ) and secure them with
screws. Then, so lder the connectors with the solder in g
pencil, with care for line intervention by solder. Connect
the male connector to the 1.6 mm thick rein fo rcing plate
and the female connector to the 1 .0 mm th ic k re inforcing
plate.
Next, align the longer connector with the shorter con·
nector. then
cut it to the same length as the shorter con·
nector.
6O-pin,
mare
connector
1. 6mm thick
r. inforclng
pl att
Connector I'Iolding screws
Solder terminar
FPC back side
Connector holding
screws
r.L...",L.~..J,L., .... 1.0"'m reinforcing
plate
6O.pin, female
co nnector
- 70 -
6-3. Soldering th e FPC PWB (DUNTK 1 060ECZZI
and main PWB
ill Fold the FPC in reference to the line shown on the
surface of the FPC {t he side the solder terminal is not
on I.
Folding line
_--1L- FPC surface
connector
. -_.
'.
~r---- --- ---,
® Evenly solder the solder terminal area on the surface of
the main PWB and clean the area with alcohol. Match
the bores in the FPC wit h the bores in the m ain PWB,
then temporarily fix using the double tack tape of the
FPC .
..
"7 '---fPC
/$///$'U/#$'/
I
® Heat the FPC PWB fr om above using the soldering
pencil to so
ld er it. (Solder temperature: 260 ° C)