Technical data

Rev.February 1996 Conti-Dryer Page 31

CD 25-600

8.0 REPAIR

8.1 Replacement of heater

1. Turn off power to the machine.

2. Remove cover (93) of casing (85)

3. Disassemble wires to heater (3) and label accordingly. Then disassemble housing (85),

on which the ﬁ re protection (83) is assembled, by loosening the three screws (84).

4. Unscrew heater of heater pipe (32)

5. Pick up new heater, and pull carefully the bars a little from eachother. Fit a new

heater after having replaced the gasket (94).

7. Fit housing (85) and wire to heater.

Heater must be connected in star or delta depending on voltage. See diagramme.

R1644