Technical data

Rev.February 1996 Conti-Dryer Page 24

CD 25-600

5.2.3 Assembly of conveyor Con-Evator PGT (11).

The conveyor Con-Evator PGT will automatically keep the drying hopper full, thus

creating an even ﬂ ow of material in the drying hopper, corresponding to the material

consumption in the production.

Assembly, see section 4.1.2

5.2.4 Level control + alarm lamp (38a) (38b)

The machine is not factory prepared for this accessory which must be ﬁ tted by an

authorized Labotek technician.

Please note that an alarm lamp (38b), giving signal at missing material condition, is

available for the vacuum conveyor type Con-Evator.

5.2.5 Assembly ﬁ xture for Mini Master-Batcher (39)

This ﬁ xture applies when it is required to dose directly into the Conti-Dryer using

Labotek’s chamber dosing unit MMB. Dosing problems may occur, as the pressure in the

Conti-Dryer may go out through the mounting base and up through to the hose to the

MMB. A special pressure compensation kit is available from Labotek in such case.

1. It is a condition that a mounting base (26) is assembled between CD and production

machine.

2. Fit assembly ﬁ xture (39) on pipe chassis (93).

3. Fit using two clips (91) hose (90) between assembly

ﬁ xture (39) and outlet pipe (92).

5. Disassemble plug in inlet

branch of mounting base by

loosening the screw retaining

it. Put the outlet pipe (92)

down in the mounting base

(26).

6. Assemble MMB on assembly

ﬁ xture and connect according

to diagram.

R1640