User Manual

13/2/06 CD-SW300HE_EN.fm
27
CD-SW300H
TINSZA165AWZZ
1
2
3
4
5
6
7
Radio
 Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours
should there be a power failure or the AC power lead become discon-
nected.
 To recall a memorised station
 To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
 To erase entire preset memory
1 Perform steps 1 - 3 in "Tuning" on page 26.
2 Press the MEMORY button to enter the preset tuning sav-
ing mode.
3 Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY button to store that
station in memory.
If the "MEMORY" and preset number indicators disappear be-
fore the station is memorised, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorised for that preset channel number will be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
1 Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired
station is located.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Whilst pressing down the button and the button, press
the TUNER (BAND) button until "TUNER CL" appears.