Service manual

CD-RW5000
– 62 –
LCD710: RUNTZ0021AWZZ
LCD DISPLAY
LCD (12 characters 3 lines)
with lcons
VLOUT
C1-
C1+
C2-
C2+
VC1
VCC
GND
/RD
/WR
/CS
/RESET
DB4-DB7
RS
3
60
7
4+COMS
7+COMS
Pin No. Pin Name Connect to DescriptionI/O
1 VLOUT Booster
capacitance
Potential difference between VCI and GND is boosted twice and then
output. Magnitude of boost is selected by instruction.
O
—
2, 3 C1-, C1+ Booster
capacitance
External capacitance should be connected here.
—
4, 5 C2-, C2+ Booster
capacitance
External capacitance should be connected here.
I
6 VCI Power supply Inputs a reference voltage and supplies power to the booster,
generates the LCD drive voltage from the operating voltage.
VCI=0~2.2V
—
7 VCC Power supply 5V
—
8 GND Power supply 0V
I
9 /RD MPU For a 80-system parallel bus interface. Read data at low level.
I
10 /WR MPU For a 80-system parallel bus interface. Write data at low level.
I
11 RS MPU "L" :Instruction; "H" :Data.
I
12 /CS MPU Low :LCD control IC is selected and can be accessed.
High :LCD control IC is not selected and can not be accessed.
I
13 /RESET MPU or external
R-C circuit
Reset pin. Initializes the LSI when low. Must reset after power-on.
I/O
14 DB4 MPU Data bit 4. For a bidirection four-bit parallel bus.
I/O
15 DB5 MPU Data bit 5. For a bidirection four-bit parallel bus
I/O
16 DB6 MPU Data bit 6. For a bidirection four-bit parallel bus
I/O
17 DB7 MPU Data bit 7. For a bidirection four-bit parallel bus