Operating instructions
32
CD-R Operation
1 Press the CDR button.
2 Load the CD, CD-R or CD-RW disc. (See page 28.)
3 Press the
0606
0606
06 button to start playback.
To interrupt playback:
Press the 06 button.
To resume playback from the same point, press the 06 button again.
To stop playback:
Press the ■ button.
The following playbacks are possible as on CDs. Page
● To locate the beginning of a track .........................................................................19
● To locate the desired portion ................................................................................19
● Programmed play ................................................................................................. 20
● Repeat or Random play........................................................................................ 21
● Switching the time display .................................................................................... 21
Notes:
● The operation “To locate the beginning of a track” on a disc on the CD-R tray plays
from the beginning of the previous track.
● During “Programmed play” on a disc on the CD-R tray, the programmed content will
be erased when the system enters the stand-by mode or when the function is changed
to a function other than CDR.
● Random play using the CD-R tray stops when all tracks have played once.
Playing discs on the CD-R tray
Recording to a CD-R or a CD-RW (continued)
To check the remaining recording time on the CD-R or CD-RW discs:
Press the DISP/CHARACTER button while recording. Each time you press the button,
the display switches as follows.
■
Sampling rate converter
This system is equipped with a sampling rate converter, which automatically converts
the sampling frequencies of the connected DSS tuners or DAT decks (32 kHz, 48 kHz)
to 44.1 kHz. You can digitally record from equipment with different sampling frequen-
cies.
Playing time
Playing time
Remaining recording time
*RW5000_P27_37(CD-R) 00.7.14, 3:52 PM32