Operating instructions

Playback

Listening to the Radio

■

Tuning

1 Press the POWER button to turn the power on.

2 Press the TUNER (BAND) button to select the desired frequency

band (FM or AM).

3 Press the TUNING (

X or

W) button to tune into the desired sta-

tion.

Manual tuning:

Press the TUNING

(X or W)

button as many times as required to tune into the

desired station.

Auto tuning:

When the TUNING

(X or W) button is pressed for more than 0.5 seconds,

scanning will start automatically and the tuner will stop at the first receivable

broadcast station.

Notes:

● When radio interference occurs, auto scan tuning may stop automatically at

that point.

●

Auto scan tuning will skip weak signal stations.

● To stop the auto tuning, press the TUNING

(X or W) button again.

4 To receive an FM stereo transmission, press the ST-MODE but-

ton on the remote control. The “ST” indicator lights up.

● “j” will appear when an FM broadcast is in stereo.

● If the FM reception is weak, press the ST-MODE button. The “ST” indicator

goes out. The reception changes to monaural, and the sound becomes clearer.

After use:

Press the POWER button to enter the power stand-by mode.

*RW5000_P18_24(Playback) 00.7.13, 3:15 PM23