Operating instructions

17
Basic Operation
To confirm the time display in the stand-by mode:
Press the DISPLAY button on the remote control. The time display will appear for
about 3 seconds.
Note:
“CLOCK” will appear or time will flash at the push of the DISPLAY button when the AC
power supply is restored after a power failure or after unplugging the unit.
Reset the clock as follows.
To reset the clock:
Perform “Setting the Clock” from the beginning.
At this time, step 5 (for selecting the 12-hour or 24-hour display) will be skipped.
To change the 12-hour or 24-hour display:
1. Clear all the programmed contents.
[Refer to “If trouble occurs (reset)” on page 44 for details.]
2. Perform “Setting the Clock” from the beginning.
Setting the Clock
In this example, the clock is set for the 12-hour (AM12:00) display.
1 Press the POWER button to turn the power on.
2 Press the MENU button.
3 Turn the jog dial to select “CLOCK” and within 10 seconds, press
the ENTER button.
4 Within 2 minutes, press the ENTER button again.
5 Turn the jog dial to select the 12-hour or 24-hour display and
within 2 minutes, press the ENTER button.
6 Turn the jog dial to adjust the hour and within 2 minutes, press
the ENTER button.
● When the 12-hour display is selected, “AM” will change automatically to “PM”.
7 Turn the jog dial to adjust the minutes and within 2 minutes, press
the ENTER button.
● The hour will not advance even if minutes advance from “59” to “00”.
● The clock starts from “0” second. (Seconds are not displayed.)
The time display will disappear after a few seconds.
“AM 12:00”→ The 12-hour display will appear. (AM 12:00 - PM 11:59)
“AM 0:00” → The 12-hour display will appear. (AM 0:00 - PM 11:59)
“0:00” → The 24-hour display will appear. (0:00 - 23:59)
*RW5000_P15_17(Basic) 00.7.8, 4:29 AM17